The machine shop contains a lot of machinery and it is very important that all hazards are not overlooked. I will use a number of different but similar methods to identify hazards within the machine shop and explain how each of these methods helps to reduce and perhaps even prevent the potential hazard. Say no to plagiarism. Get a tailor-made essay on "Why Violent Video Games Shouldn't Be Banned"? Get an Original Essay The first and most important thing I will do is carry out hazard assessment surveys (risk assessments) on a regular basis. A risk assessment is a process carried out to identify potential safety hazards and to ensure that each one is adequately understood. Furthermore, it is a question of whether current precautions and emergency plans are acceptable to reduce risks to a tolerable level or whether further action is necessary. Finally, it is about highlighting intolerable risks to determine measures to overcome or eliminate them. I will carry out risk assessments of all equipment to ensure it is in good condition and safe to use, I will carry out risk assessments of all operations to ensure certain machinery and equipment is used in the right way with the correct protective safety clothing worn, I will carry out also risk assessments and an activity analysis of all tasks to ensure they are carried out correctly and safely. However, this method is only an observation. The next method would be to look back at accident data logs (a system of recording accidents, near misses and identified hazards). This will allow me to see whether the hazard that caused past incidents has been addressed and to identify possible trends. I will investigate all reported workplace accidents and incidents. This will help find ways to address the causes of health and safety incidents so that the rate of incidents can be reduced. I will then check to see if all procedures carried out in the workshop are safe, I will check to see if safety training and correct supervision is in place for the new installer, if safety training and practice is for each new piece of equipment and I will check whether personal protective equipment is worn during certain operations and tasks. Material safety data sheets will also be examined to identify possible damage from hazardous substances and precautions to take. The next method will be to start group discussions involving everyone who works on the shop floor. We will talk about safety in the workshop which will be useful for identifying dangers and recommending solutions. Group discussions are very useful because one worker may have noticed a potential hazard that no one else had noticed. The next step would be to do a security audit. A safety audit is the collection of independent information on the efficiency, effectiveness and reliability of the entire health and safety management system and the creation of plans for corrective action. The main reason for a safety audit is to ensure compliance with health and safety legislation, including the Health and Safety at Work Act etc. 1974 and the regulations made under this Act. A security audit ensures that the systems put in place are working efficiently and are fit for purpose. I will also carry out inspections of all safety procedures. For example, are there adequate emergency exits? Aren't they blocked? Do they open? Etc... Keep in mind: this is just one.